Onkyo TX-RZ820 Basic/Advanced Manual English - Page 48
speaker terminals ZONE 2A for North American, Zone 2A+B North American models: When
View all Onkyo TX-RZ820 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 48 highlights
>>Specifications >>Advanced Setup >>Listening Modes >>Network Functions >>Basic Manual Troubleshooting | Supplementary Information, etc. Setting Item Zone Speaker Bi-Amp Speaker Impedance Default Value No No 6ohms Setting Details Set the connection of speakers to Zone 2 speaker terminals. • This setting cannot be selected when surround back speakers and height speakers are installed. "Zone 2": When speakers are connected to Zone 2 speaker terminals (ZONE 2A for North American models) "Zone 2A+B" (North American models): When speakers are connected to Zone 2A and Zone 2B speaker terminals • This setting cannot be selected when height speakers are installed. "No": When speakers are not connected to Zone 2 speaker terminals Set whether the front speakers are bi-amp connected. "No": When front speakers are not bi-amp connected "Yes": When front speakers are bi-amp connected • This item will be fixed to "No" when anything other than "No" is selected for the "Zone Speaker". • This setting cannot be selected when surround back speakers or height speakers are installed. Set the impedance (Њ) of the connected speakers. "4ohms": When any of the connected speakers have 4 Њ or more to less than 6 Њ impedance "6ohms": When the connected speakers all have 6 Њ or more impedance. • For impedance, check the indications on the back of the speakers or their instruction manual. ˙ 2� Crossover • If you are using THX-certified speakers, we recommend the following settings: - Set a value "80Hz(THX)" in Crossover frequency. - Set a value "80Hz" in "LPF of LFE". - Set a value "Off" in "Double Bass". Setting Item Front Center Height Default Value 80Hz(THX) 80Hz(THX) 80Hz(THX) Setting Details Select the crossover frequency from "40Hz" to "200Hz" to start outputting frequencies for each channel. "Full Band": Full band will be output. • If "Configuration" - "Subwoofer" is set to "No", "Front" will be fixed to "Full Band" and the low pitched range of the other channels will be output from the front speakers. Refer to the instruction manual of your speakers to make the setting. Select the crossover frequency from "40Hz" to "200Hz" to start outputting frequencies for each channel. "Full Band": Full band will be output. • "Full Band" can be selected only when "Front" is set to "Full Band". • If an item cannot be selected even though connection is correct, check that the settings in "Configuration" - "Speaker Channels" matches the number of connected channels. Select the crossover frequency from "40Hz" to "200Hz" to start outputting frequencies for each channel. "Full Band": Full band will be output. • "Full Band" can be selected only when "Front" is set to "Full Band". • If an item cannot be selected even though connection is correct, check that the settings in "Configuration" - "Speaker Channels" matches the number of connected channels. 12