Optoma W307UST User's Manual - Page 49
Replacing the lamp
View all Optoma W307UST manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 49 highlights
Appendices Replacing the lamp The projector automatically detects the lamp life. When the lamp life is nearing the end of use, you will receive a warning The screws on the message. lamp cover and the lamp cannot be removed. The projector can- Warning! Lamp Lamp is approaching the end of its useful life Replacement suggested! not be turned on if the lamp cover has not been placed When you see this message, please contact your local reseller or service center to change the lamp as soon as possible. back on the projec- Make sure the projector has been cooled down for at least 60 tor. minutes before changing the lamp. Do not touch the glass area of the lamp. Hand oil can cause the lamp to shatter. Use a dry cloth to clean the lamp module if it was accidentally 1 touched. 2 Lamp Replacement Procedure: 3 4 1. Switch off the projector power by pressing the " " button. 2. Allow the projector to cool down for at least 60 minutes. 3. Disconnect the power cord. 4. Unscrew the two screws on the cover. 1 5. Lift up and remove the cover. 2 6. Unscrew the two screws on the lamp module. 3 7. Pull up the lamp handle and remove the lamp module slowly and carefully. 4 To replace the lamp module, reverse the previous steps. 8. Turn on the projector and use "Lamp Reset" after the lamp module is re- placed. 49 English