Panasonic BT-LH910GJ Operating Instructions - Page 18
On-screen Display, Operating status display
View all Panasonic BT-LH910GJ manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 18 highlights
On-screen Display The screen shows information such as the operating status display, picture adjusting knob status, sharpness display, function display, audio level meter display, time code display, closed caption display, DC power supply voltage and battery level display, and menu display. Operating status display 1 2 56 YPBPR 1080/60i 3 P-P FILM 7 DC14.0V 50% 4 8 1. The selected input line (page 10) •• SDI1, SDI2, HDMI, VIDEO, YPBPR, VF-YPBPR/VF-VIDEO, INT SG. 2. Signal format •• "UNSUPPORT SIGNAL" appears if an unsupported signal is input. It may also indicate that the format selected in the "INPUT SELECT" menu does not match the input signal. •• "NO SIGNAL" appears without input signal. 3. Various indications (PIXEL TO PIXEL mode) •• This indicates the PIXEL TO PIXEL mode is engaged. 4. Various indications (FILM mode) •• This indicates that "GAMMA SELECT" of the "VIDEO CONFIG" is set to "FILM." 5. Various indications (warning of improper operation status for the camera settings) •• This indicates there is an improper operation status relative to the camera settings. •• The condition to display differs depending on the type and settings of the camera used in combination with the unit. For details, see the instruction manual of the camera. 6. Various displays (lock setting) •• This indicates that the front operations lock is on. (page 51) 7. DC power supply voltage display •• DC power supply voltage is displayed. 8. Battery level display •• When you are using an Anton/Bauer battery with a battery level display function, the battery level is indicated by the number of ■ and a percentage. When you are using a battery other than that or the AC adapter, the display may not be shown or the battery level may not be indicated correctly. The battery level is indicated by a numerical value in 5 % increments. Also, there are seven ■ segments to indicate the battery level, and all seven of them are displayed until the battery level is approximately 70 %. After that, the number of ■ is reduced by one for each 10 % reduction in battery power and no marks are displayed when the battery level falls below approximately 10 %. •• The indication can be turned ON/OFF in "BATTERY REMAIN" of the "SYSTEM CONFIG" menu (page 34). •• The display state of the status can be set in "STATUS DISPLAY" of the "SYSTEM CONFIG" menu (page 34). •• "UNSUPPORT SIGNAL" and "NO SIGNAL" may not be properly displayed. •• For details on the operation status display in 3D Assist mode, refer to "3D Assist Mode" (page 52). 18