Panasonic HDC-TM20-R Hd Video Camera - Page 12

Quick Guide ∫ Charging the battery Charging lamp [CHARGE] A Lights up: Charging Goes off: Charging completed 1 Connect the AC cable to the AC adaptor and the AC outlet. 2 Insert the battery into the AC adaptor by aligning the arrows. ∫ Inserting the battery Install the battery by inserting it in the direction shown in the figure. 1) Open the LCD monitor. ≥ Check that the access lamp has gone off. 2) Open the SD card cover by sliding the OPEN lever B. 3) Insert/remove the SD card. ≥ Face the label side C in the direction shown in the illustration and press it straight in as far as it will go. ≥ Press the center of the SD card and then pull it straight out. 4) Securely close the SD card cover. ≥ Securely close it until it clicks. ∫ How to turn on the power Turn on the power by changing the mode to or while pressing the lock release button A. HDC-SD20 HDC-TM20 A Insert the battery until it clicks and locks. ∫ Inserting/removing an SD card OPEN ≥ Operate the mode switch while at the same time pressing in the lock release button if changing from OFF to another mode. ≥ Status indicator B HDC-HS20 OFF Access lamp [ACCESS] A ≥ When this unit is accessing the SD card or built-in memory, the access lamp lights up. 12 VQT1Y00 ≥ Rotate the mode dial while at the same time pressing in the lock release button if changing from OFF to another mode. ≥ Align with the status indicator B. ≥ To turn off the power, change the mode to OFF.