Panasonic Handheld P2 HD Camcorder with AVC-ULTRA Recording Operating Instruct - Page 184

Chapter 9 Network Connection - Network settings @@NOTE tt There are following restrictions while wireless LAN is set. - Regardless of menu settings, signals are not output from the terminal. - The LCD monitor and viewfinder cannot be used together. If you close the LCD monitor, the viewfinder can be used. tt The startup time after turning on the power may be longer due to starting of the network. tt When you change the settings of [NETWORK SEL], the changes will not be reflected until the camera is restarted. After the settings have been changed, the setting screen termination may take time due to the restart of the network service. tt All of the IP address, subnet mask, and default gateway must be correctly set. If the warning [CANNOT ACCESS GATEWAY!] appears at the termination of the setting screen, contact the administrator of the network in use. tt If you do not use the default gateway and DNS, set them to [0.0.0.0]. tt DHCP and DNS may not function properly depending on the network environment. tt A maximum of 20 connections are saved in the connection history. When this number is exceeded, the oldest entries are deleted. tt The status of SSID connection destination list is current at the time the list was displayed and is not automatically refreshed. rr SSID connection destination list screen 1 2 34 5 1 Selection status A checkmark [l] is displayed on the currently selected SSID. (This does not show the connection status). 2 SSID The list of the detected SSID and SSID registered in the connection history are displayed. SSIDs are displayed in order from the one with the strongest signal. 3 Past connection history [H] is displayed in the SSID that has a past connection history. SSID with past connection histories are displayed even if the camera is outside the service area. 4 Encryption format This is the encryption method used by the access point. 5 Radio wave strength This shows the signal strength of the access point. [4G/LTE] mode Use the following procedure when you connect the camera with the 4G/LTE USB modem. 1 Select [4G/LTE] in the main menu → [NETWORK SETUP] → [NETWORK SEL]. 2 When the main menu → [NETWORK SETUP] → [4G/LTE PROPERTY] is enabled, select [4G/LTE PROPERTY] and configure each setting as necessary. When the setting of [4G/LTE PROPERTY] is required for the connected 4G/LTE USB modem, [4G/LTE PROPERTY] will become enabled. When following setting is required, enter the information provided from the provider accurately. [APN]: Sets the APN (access point name) provided from the provider. [USER ID]: Sets the user name provided from the provider. [PASSWORD]: Sets the password provided from the provider. [DIAL NO.]: Sets the phone number. 3 Check the network connection. Check whether to connect the camera to the network with 4G/LTE. [4G/LTE ] is displayed in the screen when network connection is correct. Also, the network status icon in the top right of the thumbnail screen will display in yellow, and the application that will use the network can be used. @@NOTE tt There are following restrictions while [4G/LTE] is set. - Regardless of menu settings, signals are not output from all external video output terminals. - The LCD monitor and viewfinder cannot be used together. If you close the LCD monitor, the viewfinder can be used. - microP2 memory cards can be used only in slot 1. (They cannot be in slot 2.) tt The startup time after turning on the power may be longer due to starting of the network. tt When you change the settings of [NETWORK SEL], the changes will not be reflected until the camera is restarted. After the settings have been changed, the setting screen termination may take time due to the restart of the network service. - 184 -