Panasonic KV-S2045C Service Manual - Page 62

KV-S2025C Series / KV-SU225C Series / KV-S2045C Series / KV-SU245C Series 9.3. Operation This section describes each operation (or status indication), according to the function item list shown in Sec. 9.2. 9.3.1. Scanner Status This function indicates scanner status, updating it every few seconds. The status messages and its contents are as follows. Classified Code - U10 U11, U12, U13, U16 U18 U23 U30 Fxx - - - Status Message Scanner has no error. No Paper! Please set the paper. Jam occurred! Please open the door and remove the paper. Document remains in scanner! Please open the door and remove the paper. Double Feed occurred! Please open the door and remove the paper. Scanner Door is open! Please close the door. System error occurred! Please consult with a service representative. *** Warning *** The rollers need to be cleaned. Please clean the rollers. *** Warning *** The rollers need to be replaced. Please replace the rollers. Scanner is not connected! Fig. 9.3.1 Scanner Status No error No paper error Contents U11: Paper Feed Jam, U12: Jam1(around conveyor) U13: Jam 2 (around conveyor), U16: Jam (around exit roller) Document remains in scanner, or dust is attached around a sensor. Double feed error. Door is open. Service level error occurred. Warning for cleaning rollers. Warning for replacing rollers. Scanner is not connected to PC properly. 9.3.2. Error Code Classified and Error codes are as follows. And troubleshooting for this error message and codes is shown in Sec. 10.2. Contents Contents Contents U1- Document H1- F1- U2- Document H2- F2- Hardware U3- Door H3- F3- U4- H4- F4- U5- H5- F5- Sensor U6- H6- F6- Scanning U7- H7- F7- U8- H8- F8- U9- H9- F9- Table 9.3.2 Classified Code Outline Table 9.3.3 Error Code Outline ST1 Error contents 0× Communication error 1× Paper jam error 2× Door open error 3× Mechanical function error 4× Paper sensor error 5× Scanning error 6× - 7× - 8× Hardware error 9× Hardware error A× - B× - C× - D× - E× - F× - 62