Panasonic KXFPG376 KXFPG376 User Guide - Page 66
Direct commands for programming features, 4.1 Program code and direct, command button
View all Panasonic KXFPG376 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 66 highlights
8. Programmable Features To transfer a recorded incoming message to another telephone (page 58), activate this feature and program the transfer telephone number. 1. Press {MENU}. 2. Press {#}, then {6}{0}. 3. Press {A} or {B} repeatedly to select "ON". 4. Press {SET}. 5. Enter the transfer telephone number. 6. Press {SET}. 7. Press {MENU}. Code #61: Checking, recording or erasing the transfer greeting message TRNS-GREETING CHECK [±] See page 58 for details. Code #67: Setting the incoming message monitor ICM MONITOR MODE=ON [±] To hear an incoming message (ICM) from the speaker when the answering machine is recording the message. "ON" (default): You can monitor the incoming message. "OFF": Deactivates this feature. Code #70: Calling your pager PAGER CALL MODE=OFF [±] See page 59 for details. Code #76: Setting the connecting tone CONNECTING TONE MODE=ON [±] If you often have trouble when sending faxes, this feature allows you to hear connecting tones; fax tone, ring back tone and busy tone. You can use those tones to confirm the status of the other party's machine. L If the ring back tone continues, the other party's machine may not be a facsimile or may have run out of paper. Check with the other party. L The connecting tone volume cannot be adjusted. "ON" (default): You will hear connecting tones. "OFF": Deactivates this feature. Code #77: Changing the receiving mode in the AUTO ANSWER setting AUTO ANSWER MODE=TAM/FAX [±] "TAM/FAX" (default): Telephone Answering Machine/Fax mode (page 45) "FAX ONLY": Fax only mode (page 46) Code #80: Resetting advanced features to their default settings SET DEFAULT RESET=NO [±] To reset the advanced features: 1. Press {MENU}. 2. Press {#}, then {8}{0}. 3. Press {A} or {B} repeatedly to select "YES". 4. Press {SET}. 5. Press {SET} again. 6. Press {MENU}. 8.4 Direct commands for programming features You can also select the desired setting by directly entering the program code (# and a 2-digit number) and direct command. For more details on the features, see page 60 to page 64. 1 Press {MENU}. 2 Press {#} and the 2-digit code number. 3 Press the desired direct command, using the dial keypad, to display the desired setting. L This step may be slightly different depending on the feature. 4 Press {SET}. 5 To exit programming, press {MENU}. 8.4.1 Program code and direct command button {#}{0}{0} Quick Setup - {1}: "TAM/FAX" (default) - {2}: "DIST. RING" - {3}: "TEL ONLY" - {4}: "FAX ONLY" L Press {SET} 2 times before pressing the direct command button. 64