Panasonic PV-GS250 Digital Video Camera - Page 49

Edit mode ª To cancel the standby for recording When the Camcorder is in standby for recording, move the joystick down and select the [∫] icon. ≥Do not plug or unplug the DV cable during dubbing, or the dubbing may not be completed properly. ≥If a picture (bilingual video, etc.) containing main sound and sub sound has been dubbed, select the desired sound using [SETUP] >> [AUDIO OUT] on playback. ≥Even if you use a device equipped with DV terminals such as IEEE1394, you may not be able to perform digital dubbing in some cases. For more information, see the instructions for equipment connected. ≥Regardless of the menu settings on the recorder, digital dubbing is carried out in the same mode as the [AUDIO REC] mode of the playback tape. ≥The images on the recorder monitor may be disturbed, but it does not affect the recorded images. ≥If a picture containing a copyright protection signal (copy guard) is recorded by the Camcorder, the picture is distorted by mosaic-like patterns at playback. ≥Disconnect the USB cable since input signals from the external input terminal cannot be recorded while it is connected with the USB cable. ≥When wide images are input, the display such as the menu screen or the operation icon is expanded horizontally. ≥While pictures are input from the DV terminal, the operation icon blinks on instead of appearing from the side of the screen when you press the center of the joy stick. CAUTION: Unauthorized exchanging and/or copying of copyrighted recordings may be copyright infringement. Audio dubbing You can add music or narration to the recorded cassette. ≥Set to Tape Playback Mode. (If you perform external input, set [BASIC] >> [AV JACK] >> [IN/OUT], and connect an input device.) Audio dubbing using the microphone terminal 1 Insert a Magic Wire Remote Control with Narration Mic or an external microphone securely into the [REMOTE/MIC] terminal as far as it will go. REMOTE/MIC 2 Set [ADVANCE] >> [A. DUB INPUT] >> [MIC]. Audio dubbing (external input) using other equipment (audio equipment, etc.) 1 Insert the AV cable (supplied) securely into the AV terminal as far as it will go. AV/ 2 Set [ADVANCE] >> [A. DUB INPUT] >> [AV IN]. 3 Find a scene that you want to add sound to, and press the [;] button on the remote control. V/REW PLAY FF/W W ; STILL ADV PAUSE STILL ADV VOL STOP 4 Press the [A.DUB] button on the remote control to make audio dubbing ready. ¥REC A.DUB ZOOM T V/REW PLAY FF/W STILL ADV PAUSE STILL ADV W VOL A.DUB ; 49 LSQT0862