Panasonic PVDV203 PVDV203 User Guide - Page 49

Card Features Card PhotoShot You can record still images to a Memory Card. Warning • When using an M-CARD, DV Output will not function. 3PHOTOSHOT 2JOG KEY 2MENU 1POWER Before you begin • Connect the Palmcorder to a power source. (pp. 15, 16) • Set POWER to OFF before inserting a Memory Card. (p. 14) 1 Set POWER to M-CARD. • The POWER lamp lights red. • Be sure POWER is fully turned to M-CARD position. • "PLAY: PUSH PLAY KEY" is displayed for 10 seconds. (p. 51) 2 Press MENU to display CARD SETUP menu, then press JOG KEY to select NORMAL or FINE . Card Features Image Resolution and Capacity (Supplied 8MB Memory Card) REC Image Mode Resolution Capacity FINE 1280 x 960 Approx. 30 images NORMAL 640 x 480 Approx. 70 images • The number of images given for each mode applies when all images are taken in same mode. • You can change recording modes at any time before capturing an image. • The number of images that can be captured may differ depending on the subject. After capturing an image, the number may not decrease, or it may decrease by two. This is normal. Note • 1280 x 960 PhotoShot image is interpolated from 640 x 480 image. • Some artifacting, softened edges or picture noise may occur in Fine (1280 x 960) Mode. • PhotoShot capture time for Fine Mode (1280 x 960) is approximately 10 seconds, and for Normal Mode (640 x 480) is approx. 5 seconds. • Press MENU to exit this menu. 3 Press PHOTOSHOT to record an image. • The PhotoShot image is recorded to the Memory Card. • When SHTR EFFECT is set to ON (Menu OSD: p. 109), still pictures are recorded with a visual shutter effect and click sound. If set to OFF, the still image will be displayed only. Warning • While "PROCESSING" is displayed, DO NOT turn off the Palmcorder or unplug the AC Adaptor (supplied) because this will cause irreversible damage to the memory. • When recording DV Tape playback output to the Memory Card, only NORMAL mode is available. (p. 50) 49