Panasonic SAHT730 Dvd Theater Receiver - Page 5

Front speaker assembly [HT930] [Note] To prevent the speaker cables from being pulled out of the pipes, leave the plastic wrap on the pipes while assembling the speaker stands. 2 Front speakers 2 Pipes 2 Bases 4 Long screws 4 Short screws 1 Assemble the speaker stands. 1 Thread the speaker cable through the base. For quicker threading, loosely fold the cable in half (do not crease), pass the folded portion through the hole, and then pull the rest of the cable through the base. Plastic wrap Leave the excess speaker cable for connecting later. Cable Base 2 Insert the pipe. Pipe Groove Pipe support Insert the pipe while gently pulling on the speaker cable. Match the groove and these holes with the base when you insert the pipe. Base 3 Secure the pipe to the base. Ensure the screws are securely fastened. Phillips-head screwdriver (not included) Short screws Before proceeding to the next step, please remove the plastic wrap from the pipe. 2 Attach the stands to the speakers. Ensure the stand is fastened on straight by gradually tightening the top and bottom screws alternately until fully tightened. Long screws Pipe Front speaker You can also attach to the lower rear of the speaker. The height of the speaker can be changed when attaching the stand to the upper rear or lower rear of the speaker. 3 Connect the speaker cables. Rear of the speaker Twist off the vinyl tips of the speaker cables. ≥If the speaker cables do not have vinyl tips, directly connect them to the terminals. _: Copper `: Silver Push! Press the speaker cable into the groove. If there is any excess speaker cable, thread the speaker cable into the opening near the top of the pipe while pulling the speaker cable from the bottom of the base. 4 Secure the speaker cables to the bases. Press the speaker cable into the base cover groove as far as possible. Cable Rear side of base Groove RQT7972 5