Panasonic SC-HT56 Home Theater - Page 13

Settings Change the settings to suit your equipment to the environment in which you are using it. Before making any changes, read the descriptions of the settings, note the factory settings and ranges, and refer to the equipment's instructions. Switch on. 1 Enter the setup mode. 2 Select the item you want to change. Display 3 Change the setting. 4 Exit the setup mode. Settings Press and hold. 2a Select and press [ENTER]. DISTANCE ↔ AUTO SETUP ↔ INPUT MODE ↔ HDMI ↔ DRCOMP ↔ ATTENUATOR ↔ REMOTE ↔ TV DELAY ↔ RESET ↔ EXIT • Refer to pages 13 and 14 for each item settings. • For "REMOTE", refer to page 21. • For "RESET", refer to page 19. 2b Select and press [ENTER]. Press to change the setting. Press once to enter. Press repeatedly until "EXIT" appears. Press [ENTER] to completely exit the setup mode. Note Auto speaker setup calibration will give optimal result for "DISTANCE". Therefore, you are unable to adjust the setting manually. 2a 2b 3 Distance • Enter the distance of the front, center and surround speakers from the seating position. Change the distance so that the sound from all the speakers (except for the subwoofer) reaches you at the same time. You can select distances between 3 feet and 30 feet. The factory settings are: LR (front): C (center): S (surround): 10 ft (feet) 10 ft (feet) 5 ft (feet) Auto setup • Reset the settings done in auto speaker setup. YES: Reset all auto speaker setup settings NO: To cancel (factory setting) DISTANCE LR C S 3 feet to 30 feet Repeat for each speaker channel AUTO SETUP DEFAULT NO YES Input mode • This unit automatically detects whether input is digital or analog, but you can fix the input mode. AUTO: The unit automatically detects whether input is digital or analog. (factory setting) ANALOG: Select to make the unit accept analog input. DIG: Select to make the unit accept digital input. PCMFIX1: Select to input to PCM. INPUT MODE TV DVR DVD AUTO ANALOG DIG PCMFIX 1 In rare cases, the unit may have trouble recognizing PCM signals and this may cause the beginning of tracks to be cut off. Select "PCMFIX" if this occurs. • With DTS, the signals may not be recognized at all. Engage the DTS FIX mode if this occurs. To engage the DTS FIX mode: Press and hold [-MENU] and [ENTER] at the same time. "DTS" lights. To cancel the DTS FIX mode: Press and hold [-MENU] and [ENTER] at the same time. RQTX0175 The mode cancels when input mode is set to AUTO or when the unit is turned off. Note When a FIX mode is on, the unit cannot process other signals. This may cause noise to be output. If this occurs, select an input mode other than PCMFIX, or cancel the DTS FIX mode. 13 (continue on next page)