Panasonic SL-1200MK7R Owners Manual - Page 13
English, Installation, Fit the dust cover, unit horizontal
View all Panasonic SL-1200MK7R manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 13 highlights
Installation Getting started Install the unit on a horizontal surface protected from vibrations. Keep this unit as far as possible from speakers. Adjusting the height to make the unit horizontal Increases the height Reduces the height Raise the main unit to turn the insulators and adjust the height. Clockwise: Reduces the height. Counterclockwise: Increases the height. Attention Do not turn the insulators too far. Doing so may cause them to come off or damage them. Fit the dust cover 1 While holding the dust cover from both sides, put it in place by aligning its four corners with the four corners of the unit. When removing, lift the dust cover straight up. Notes for installation Before you move the unit, turn the unit off, pull out the power plug and disconnect all connected devices. Ensure the unit is not exposed to direct sunlight, dust, humidity, and heat from a heating appliance. This unit may pick up interference from a radio if there is one nearby. Keep the unit as far as possible from a radio. Do not install the unit on a heat source. Avoid a place with large temperature variations. Avoid a place with frequent condensation. Avoid an unstable place. Do not put an object on the unit. Do not install the unit in a confined space such as a book shelf. Install the unit at a position well away from walls or other devices to ensure effective heat radiation from the inside of the unit. Make sure the installation location is sufficiently strong to withstand the total weight of the unit and system. ( 23) Note that the unit may be damaged by cigarette smoke or moisture from an ultrasonic humidifier. Condensation Think of taking out a cold bottle from a refrigerator. If you leave it in a room for a while, dewdrops will form on the bottle surface. This phenomenon is called "condensation". Conditions causing condensation Rapid temperature change (caused by moving from a warm place to a cold place or vice versa, rapid cooling or heating, or direct exposure to cooled air) High humidity in a room with much steam, etc. Rainy season Condensation may damage the unit. If it has occurred, turn the unit off and leave it until it adapts to the ambient temperature (approximately 2 to 3 hours). Attention Return the tone arm to the arm rest and fix it with the arm clamp before you attach or detach the dust cover. Remove the dust cover while playing. Be sure the stylus light ( 19) is pressed down when attaching the dust cover. If the dust cover is attached with the stylus light raised, it may touch the dust cover. 13 (13) English