Panasonic WVCW974 WVCW974 User Guide - Page 21

Operation Examples This section describes a number of camera operation examples. For details about operation, see page 41 (Auto Tracking Settings) of this manual, and the user documentation that comes with the peripherals you are using. Operation Example 1: When following a preset sequence (with alarm output), the camera switches to auto tracking when it reaches a particular preset position, and then returns to the preset sequence after 30 seconds of auto tracking. Alarm Output 1 Auto Tracking Stop Sequential Movement Auto Tracking In Progress 30 seconds Sequential Movement 1. Configure the PRESET settings (page 33). Register each preset position. For each registered preset position, select ON for AUTO TRACK for the positions you want to include in the auto tracking. Auto tracking will not include any preset position whose AUTO TRACK setting is OFF. PRESET NO. 1* POSITION SET PRESET ID ON ALC/MANUAL ALC AF MODE MANUAL L DWELL TIME 10S SCENE FILE 1 PRESET SPEED I255 L H AUTO TRACK ON RET TOP DEL 2. Configure the AUTO MODE setting (page 35). Select SEQ for the AUTO MODE setting. **PAN/TILT SETUP**1/2 PRESET 1 MAP HOME POSITION OFF SELF RETURN OFF AUTO MODE SEQ AUTOPAN KEY AUTO PAN PATROL PRIVACY ZONE OFF IMAGE HOLD OFF DIGITAL FLIP ON PROPO.P/T ON 3. Configure the AUTO TRACK setting (page 41). Select ON for the ALARM setting. Configure the other parameters in accordance with the operating environment. ** AUTO TRACKING ** CAMERA HEIGHT 2.50M OBJECT SIZE SMALL SENSITIVITY MID TRACKING MODE MID ZOOM CONTROL CONTINUOUS AUTO RELEASE OFF LOST MODE ZOOM-OUT ALARM ON AREA SET INDICATOR OFF RET TOP Important: Failure to configure settings in accordance with the operating environment can cause operational errors. Configure the settings while carefully checking the AUTO TRACK setting (page 41). Note: If the alarm is turned on, an alarm signal is continually output from ALARM OUT 1 while an auto tracking operation is in progress. 4. Configure ALARM IN/OUT settings (page 45). Select ALARM for CNT-CLS1. **ALARM IN/OUT** ALARM IN1 OFF ALARM IN2 OFF ALARM IN3 OFF ALARM IN4 OFF CNT-CLS 1 TIME OUT CNT-CLS 2 COAX ALM OUT ALARM 100MS OFF OFF RET TOP 5. Configure the SELF RETURN setting (page 35). Select either 30S or SEQ. **PAN/TILT SETUP**1/2 PRESET 1 MAP HOME POSITION OFF SELF RETURN 30S SEQ AUTO MODE SEQ AUTOPAN KEY AUTO PAN PATROL PRIVACY ZONE OFF IMAGE HOLD OFF DIGITAL FLIP ON PROPO.P/T ON Operation Example 2: While auto panning, the camera moves to Preset Position 1 in accordance with input at ALARM IN 1 and then performs auto tracking. To return to auto panning operation one minute after auto tracking starts (50 seconds of auto tracking and 10 seconds of self-return) Alarm IN 1 Auto Tracking Ends Auto Panning Auto Tracking Enabled 50 seconds Auto Panning 10 seconds -21-