Panasonic fv08vsl1 Installation Instructions - Page 14

MAINTENANCE II (REPLACEMENT OF LAMP) CONTINUED 1. Remove grille. (Squeeze mounting spring and pull down) (Fig.22 of page 13) Plug connectorII lug connector lII 2. Disconnect connector II or connector III from lighting unit. (Fig.26) Receptacle lII Receptacle It 4 W Night Lamp Fluorescent lamps Fig.26 3. Change the fluorescent lamps (Panasonic FDS 18E27/4,18 W or FDS18E35/4, 18 W or FDS18E42/4, 18 W ) or the 4 W night lamp, connect the connector II or connector HE and replace the grille. (Fig.27) Fig.27 PRACTICAL GUIDE TO INSTALLATION Proper insulate the area around the fan to minimize building heat loss and gain. (Fig.28) Loose fill or batt insulation can be placed directly over the fan housing in the attic. Panasonic fans and fan/light combination units do not create excessive heat that is a common problem with recessed light fixtures or some competitors' fan/light combinations. Our efficient, cool-running motors and our fluorescent lamps do not create enough ambient heat to be subjected to these limitations. Dryer-hood type vent with backdraft flap (s). Caulk termination to duct. 2-3 ft straight run before elbow. In attic installation, caulk box to drywall. Short piece of flexible duct helps alignment and absorbs sound. Clamps plus tape at all flex joints. Foil tape tightly covers all metal duct joints (glue PVC joints). Insulation Fig.28 PRODUCT SERVICE Warning Concerning Removal of Covers. The unit should be serviced by qualified technicians only. No service information is provided for customers. Your product is designed and manufactured to ensure a minimum of maintenance. However, should your unit ever require service, a nationwide system of factory service centers and AUTHORIZED INDEPENDENT SERVICE CENTERS is maintained to support your product's warranty. (In the U.S.A.,call 1-866-292-7292 to Customer call Center.) 14