Pantech Jest 2 Manual - English - Page 12
Install Battery, Remove Battery, Charging Your Battery
View all Pantech Jest 2 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 12 highlights
INSTALL BATTERY 1. Insert your finger tip into the slot (1), then push down on top of the battery cover and slide it off to remove (2). 2. Slide the battery into the slot by aligning the contacts and press down until you hear the"click". Attention1:4N0e pas /60 ex).poNseerpaasdvdeesénitrmeoemnntpecer.oanttNuaerctepsas Attenti (Ex:Recycling number 1-800-822-8837) or expose to fire. To dispose of properly circuit the battery terminals. Do not incinerate Do not allow metal objects to contact or short Cuidado: No exponga a alta temperatura (140 /60 ). No desensamble. No permita que objetos de metal entren en contacto o hagan cortocircuito con los terminales de la batería. No incinere ni exponga al fuego. Para eliminar en forma adecuada (Por ejemplo:Número de reciclaje 1-800-822-8837) (140 /60 ). Do not disassemble . Caution:Do not expose to high temperature (Ex:numéro de recyclage 1-800-822-8837) Pour mettre au rebut adéquatement Ne pas incinérer ni faire brûler. avec les bornes de pile ni les court-circuiter. laisser des objets métaliques venir en contact élevées (140 /60 ). Ne pas démonter . Ne pas Attention: Ne pas exposer a des tempe atures Correct Incorrect 3. Align the cover tabs with the slots on the back of the device and slide the battery cover onto the unit until it snaps into place. If the battery is not correctly placed in the compartment, the handset will not turn on and/or the battery may detach during use. Correct Incorrect 20 REMOVE BATTERY 1. To remove the battery cover, insert your finger tip into the slot (1), then push down on top of the battery cover and slide it off (2). 01 02 2. Insert your fingernail into the slot and lift the battery, and pull the battery. 03 04 3. Align the cover tabs with the slots on the back of the device and slide the battery cover onto the unit until it snaps 05 into place. 06 07 CHARGING YOUR BATTERY 1. Connect the USB data cable into the cableless wall adapter. 2. Plug the USB data cable into the phone's Charging/Data Port (making sure to align the connector as it appears in the image to the right) and the wall adapter end into an electrical outlet. • If the battery connector is not properly aligned, damage could occur to the charging connector and the phone may not charge. • The main plug is used as the disconnect device and remains readily operable. 201