Pentax MG2E60-BLK Operation Manual - Page 167

Troubleshooting Problem Cause Remedy The batteries are not Check if the batteries are installed. If not, installed install batteries. The camera will The batteries are not turn on installed incorrectly Check orientation of the batteries. Reinsert the batteries according to the +- symbols in the battery compartment. (p.19) The batteries are exhausted Insert new batteries or use the AC adapter. The camera is connected to a No image appears computer on the display The camera is connected to the AV equipment The display is off when the camera is connected to a computer. The display is off when the camera is connected to an AV equipment. The brightness level of the display is set too dark Adjust the brightness level in [Brightness Level] in the [W Setting] menu. (p.152) The display is hard to see When the Power Saving function is on, the display automatically darkens after a Power Saving function is on certain amount of time. Press a button to return to the normal brightness level. Select [Off] in [Power Saving] in the [W Setting] menu to turn the Power Saving function off. (p.153) The flash is charging Pictures cannot be taken while the flash is charging. Wait until charging is finished. The shutter will not release There is no available space on the SD Memory Card or in the built-in memory Insert an SD Memory Card with available space or delete unwanted images. (p.23, p.108) 9 Recording Wait until recording is finished. The picture is dark when using the flash The subject is too far away in a dark environment, such as a night scene The picture becomes dark if the subject is too far away. Take picture within the specified flash range. Appendix 165