Pentax UC-1 UC-1 Manual - Page 38
unnecessary
View all Pentax UC-1 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 38 highlights
Correcting the date Switch the power on by opening the lens protector. I. Keep depressing the Date button 0 for 3 seconds, the "Year" digits will blink. 2. Each time the Date button 0 is depressed, the blinking digits change in the following manner : Year-Month-Day-Time-Minute Stop depressing the button when the desired digits appear. 3. Depress 0 or 0 button, when you wish to change the blinking digits. The digits change e one by one each time the button 0 or the button is depressed. If the button is kept depressed, the digits will, e in two seconds or three, change continuously. Depressing the button increases the digits and depressing the button 0 decreases the digits. 4. After the data has been adjusted, depress the date button 0 each time until blinking stops. • The blinking "minute digits" allow precise fine-tuning of the internal clock to the biginning of a specified minute. To do so, when the "minutes digits" are blinking , depress the DATE button 0 in sync with a time signal. 34 O DATE (1E. Select button Adjust button (increase) Mode button (decrease) • The- -- -bar marks will appear after replacing the battery. • For correction after replacing the battery, the Year digits will blink if the button 0 is depressed only once, unnecessary to depress it for 3 seconds. Follow the steps listed above to reset the time and date.