Pfaff 295-1 Owner's Manual - Page 11

To prepare your macnine for darnnc. pro ceed as follows: Darning toot No 93-106103-91 Replace he ordinary sewing foot by darn ing foot No. 93-106103-91. attaching it from the rear so that soring clip c rests on needle set screw i22l Tighten sewing foot thumb screw (16). Lower the presser bar lifter Now tte machine feed has to be drohped To do this, push the drop-feed button to the right to position B. To raise the feed again. press inc button down and push P oaCK to posit:on A for sewing. --C 4 1* kcz J. r Draw up tOe bobbin thread and hold both threads lightly with your eft hand while the first stitches are being made. Trim the threads and start stitching back and forth across the hole in sewing direction Make sure the threads are anchored in tne unworn area around the hole. Turn the faoric at right angles and sew bacK and forth over the preceding work with short stitcrtes. If th.e needle thiead should break, the up per tension is too tight. Darning sheer and soft materials :5 greatly facilitated by placing them in darning hoops. Select the darning hoops in a size match ing the darning ioD to be performed.