Pfaff expression 150 Owner's Manual - Page 6
Presser feet - manual
View all Pfaff expression 150 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 6 highlights
Presser feet Standard presser foot 0A with IDT™ system (attached on the machine upon delivery) This foot is used mainly for straight stitching and zigzag stitching with a stitch length longer than 1.0 mm. Fancy stitch foot 1A with IDT™ system This foot is used for decorative stitches. The groove on the underside of the foot is designed to Áow smoothly over the stitches. Fancy stitch foot 2A When sewing decorative stitches or short zigzag stitches and other utility stitches with less than 1.0mm stitch length, use this foot. The groove on the underside of the foot is designed to Áow smoothly over the stitches. Blindhem foot 3 with IDT™ system This foot is used for blindhem stitches. The toe on the foot guides the fabric. The red guide on the foot is designed to ride along the fold of the hem edge. Zipper foot 4 with IDT™ system This foot can be snapped on either the right or the left of the needle, making it easy to sew close to both sides of the zipper teeth. Move the needle position to the right or left to sew closer to zipper teeth. Sensormatic buttonhole foot 5A When connected to the machine, the buttonhole is sewn in a suitable length to the button size that has been entered into the machine. Manual buttonhole foot 5M This foot is used for sewing manual buttonholes. Use the markings on the foot to position the garment edge. The Ànger on the back of the foot holds cording for corded buttonhole. Free-motion/Darning foot Insert the pin of the foot as far as it will go into the hole at the back of the presser foot holder. The "C-shaped" guide should be positioned around the presser foot bar. The long arm must be behind the needle bar. Tighten the screw. Important: Make sure that the IDT™ system is disengaged when using presser foot 2A, 5A, 5M and the free-motion/darning foot. 6 - Introduction