Pfaff hobby 1132 Owner's Manual - Page 41

Utility stitches and practical sewing 2:15 stitch D adjust 0 3-7 B Button sewing With zigzag stitch D you can sew on twoand four-hole buttons. Note: Lower the feed dog when sewing on buttons. Adjust the stitch width to match it with the span of the holes in the button. Turn the handwheel to check if the needle enters into each hole in the button. Lower the foot to hold the button in place. The holes in the button should align with the slot of the foot. A pin can be placed on the foot to form a shank. Make sure to check if the needle enters into both holes in the button. Sew about 10 stitches. Note: When sewing a four-hole button, move the button to the other pair of holes, and sew the button again. Raise the presser foot and remove the fabric. Cut the needle and bobbin threads leaving 20 cm (8") tails. Bring the needle thread between the button and fabric through the holes in the button. Pull the needle thread to pick bobbin thread up to the right side of the fabric. Wind the threads to form a shank and tie them together. Note: Raise the feed dog after sewing.