Philips SRC2063 User manual (English) - Page 4
DTV, Cable / Satellite box, DVR - codes
View all Philips SRC2063 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 4 highlights
English Getting started 3 Look up the 4-digit code for your brand in the brand list at the back of this user manual. A 4-digit code is shown for each brand. Use the digit buttons to enter the code for your brand. • If the red Setup light turns off, an invalid code was entered. In this case, 5-60SEC. try again. 4 Aim the remote 5 - 60 sec. control at the TV. Press and hold the button. Release it immediately as soon as the TV switches off. • This step normally takes between 5 and 60 seconds. In extreme circumstances this step can take up to 15 minutes. 5 Switch ON the TV. Try out the buttons that you need for operating it.Try, for example, if the - CH + and digit buttons function properly. • If a button does not work as expected, press and hold that button. Release it immediately as soon as it works. For more information, see chapter 2.2.2. 6 Press the device selection button twice to finish setup. 2 x • When no button is pressed for 5 minutes or more, the remote control will exit setup mode, automatically saving all your settings. Important If you made a mistake: • Press the device selection button twice to exit setup.The red Setup light turns off. • Restart from the beginning. • If the device does not respond at all or not to all of the button commands or if you cannot find the code for your brand, enter '9, 9, 9, 9' in step 3 and continue with step 4.The remote control will now search its full database for a code that works with your TV. Full database search may take up to 15 minutes. 2.2.1 Setting up the remote controls for other devices (DVD player / recorder, DTV, Cable / Satellite box, DVR and VCR) 1 Make sure the device is switched on and operational. E.g. insert a disc in the DVD player / recorder or a video cassette in the VCR (SRP2006 only). 2 Then follow steps 2 to 6 of 'Setting up the universal remote controls to operate your TV'. Make sure to use the correct device selection button: - for SRP2003: or . - for SRP2006: , , , or . 2.2.2 Improving buttons When correctly set up, the remote control should be able to operate all your devices. However, when using the remote control for the first time it might occur that some buttons do not yet function as expected. In this case you can have the remote control search for alternatives. Note Improving buttons is not possible when the code was found during full database search (with code '9, 9, 9, 9'). 6 EN EN 7