Philips SRM7500 User manual - Page 26

26 SRM7500 - Instructions for Use Problem I want to quit the installation wizard. Cause Solution To quit the installation wizard you press or once. ■ When you did not yet install a connection to the PC, the remote will restart the wizard on your SRM7500. ■ When you installed the connection to the PC already, the remote will turn into the music controller. To install a device, you need to add each device individually like described in chapter 'Add a Device' on page 16. Enjoying Your SRM7500 Problem Cause The No Connection The SRM7500 is too icon blinks in far from the PC to the upper right-hand set up a connection. corner of the screen. Solution The SRM7500 should be maximum 33 ft (10 m) from the PC. Obstructions in the path from the remote to the PC can reduce this distance. The PC is not powered. Turn on your PC. The PC is in standby mode. It can take a while for the PC to start up after standby mode. During start-up, you will see the No Connection icon blinking on the remote. The MediaControl software is disabled. Check the icon in the taskbar. When the icon is blue, the software is disabled. To enable the software, right-click the icon in the taskbar and select Enable. The icon will turn green . © 2007 - Philips Innovative Applications, Interleuvenlaan 74-76, 3001 Leuven (Belgium) SRM7500 - Instructions for Use