Philips TSU500 User manual - Page 28
Setup, Revert
UPC - 077703566348
View all Philips TSU500 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 28 highlights
FAQ How do I reset the ProntoNEO? Under normal circumstances, you will never have to reset the ProntoNEO. However, on rare occasions, if the ProntoNEO's touch screen freezes or if you notice unusual behavior, you need to perform a reset to get the ProntoNEO running again. All customized commands and devices are retained. 1 Slide the battery cover off the back of the ProntoNEO. You will see the Reset button in the battery compartment. 2 Use an unfolded paperclip or a sharp pencil to carefully press the Reset button. The ProntoNEO restarts and an Introduction screen appears. The ProntoNEO beeps twice to indicate it is ready for use. Reset button How do I revert to the original configuration? Reverting to the original configuration restores the ProntoNEO's devices and commands to its state when you purchased it. This means that all programming is lost permanently. Normally, you never have to revert the ProntoNEO. See 'Revert' on p. 14. 1 Press and hold the Mode button for 3 seconds. The mode screen appears. 2 Tap the Setup button. 3 Scroll to the third setup page. 4 Tap the Revert button. A message screen appears to confirm or cancel the revert process. 5 Press OK or Cancel. Do I have to calibrate the touch screen? The ProntoNEO's touch screen is calibrated when it leaves the factory. You only have to calibrate the LCD touch screen when you upgrade ProntoNEO's software in the future. User Manual 28