Pioneer AVIC-X940BT Owner's Manual - Page 174
Setting for rear view camera, Adjusting the response, positions of the touch panel, touch panel
View all Pioneer AVIC-X940BT manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 174 highlights
Chapter 31 Customizing preferences Setting for rear view camera The following two functions are available. The rear view camera feature requires a separately sold rear view camera (e.g. ND-BC5). (For details, consult your dealer.) Rear view camera The navigation system features a function that automatically switches to the full-screen image of the rear view camera installed on your vehicle. When the shift lever is in the REVERSE (R) position, the screen automatically switches to full-screen rear view camera image. Camera for Rear view mode Rear view can be displayed at all times (e.g. when monitoring an attached trailer, etc.) as a split screen where map information is partially displayed. Please be aware that with this setting, camera image is not resized to fit, and that a portion of what is seen by the camera is not viewable. = For details, refer to Setting for rear view camera on this page. CAUTION Pioneer recommends the use of a camera which outputs mirror reversed images, otherwise the screen image may appear reversed. p Immediately verify whether the display changes to a rear view camera image when the shift lever is moved to REVERSE (R) from another position. p When the screen changes to full-screen rear view camera image during normal driving, switch to the opposite setting in "Polarity". 1 Display the "System Settings" screen. = For details, refer to Displaying the screen for system settings on page 170. 2 Touch [Back Camera]. The "Back Camera Settings" screen appears. 3 Touch [Camera]. This changes the setting to "On". p You can only switch to "Rear View" if this setting is "On". 4 Touch [Polarity] to select an appropriate setting for polarity. Each time you touch [Polarity] switches between the following polarity: ! Battery: When the polarity of the connected lead is positive while the shift lever is in the REVERSE (R) position ! GND: When the polarity of the connected lead is negative while the shift lever is in the REVERSE (R) position Adjusting the response positions of the touch panel (touch panel calibration) If you feel that the touch panel keys on the screen deviate from the actual positions that respond to your touch, adjust the response positions of the touch panel screen. p Do not use a sharp pointed tool such as a ballpoint pen or a mechanical pen, which could damage the screen. 1 Display the "System Settings" screen. = For details, refer to Displaying the screen for system settings on page 170. 2 Touch [Screen Calibration]. A message confirming whether to start the calibration appears. 3 Gently touch the center of + mark displayed on the screen. The target indicates the order. After you touch all marks, the adjusted position data is saved. p Do not turn off the engine while saving the adjusted position data. # If you press the MODE button, the previous adjustment position returns. # If you press and hold the MODE button, the adjustment is canceled. 174 En