Pioneer AVIC-X950BH Installation Manual - Page 21
Installation
View all Pioneer AVIC-X950BH manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 21 highlights
Installation Section 03 English ! The cords must not cover the area shown in the figure below. This is necessary to allow the amps and navigation mechanism to dissipate heat. Do not cover this area. ! The semiconductor laser will be damaged if it overheats, so don't install the navigation unit anywhere hot - for instance, near a heater outlet. Installation using the screw holes on the side of the navigation unit % Fastening the navigation unit to the factory radio-mounting bracket. Position the navigation unit so that the brackets screw holes and its screw holes are aligned, and tighten the screws at three locations on each side. Use either the truss head screws (5 mm × 8 mm) or flush surface screws (5 mm × 9 mm), depending on the shape of the bracket's screw holes. Parts supplied Parts marked (*) are supplied with AVICX950BH, AVIC-X850BT and AVIC-X8510BT. If the pawl interferes with installation, you may bend it down out of the way. Factory radio-mounting bracket The navigation unit Truss head screw (5 mm × 8 mm) (6 pcs.) Flush surface screw (5 mm × 9 mm) (6 pcs.) Screw* (2 mm × 4 mm) (1 pc.) Truss head screw or flush surface screw Be sure to use the screws supplied with this navigation system. Dashboard or console En 21