Pioneer MEP-7000 Control Manual for the DJS Software - Page 7

2 Chapter 2 Manipulator Style The Manipulator style uses the MEP-7000's Control unit but does not use the MEP7000's Drive unit. It is necessary to install the driver software before connecting a MEP-7000 to your computer. Please do not connect the MEP-7000 to your computer until you have finished installing the driver software. For information on how to install the driver software, please refer to "ABOUT THE DRIVER PROGRAM" in the Operating Instructions of your MEP-7000. When 2 or more MEP-7000s are connected If you connect two or more MEP-7000s to your computer, only the first MEP-7000 will be able to operate DJS. 2-1 Connecting to your computer Connect the MEP-7000 to your computer with a USB cable and a USB auxiliary power cable. For information on each of the cables that come with the MEP-7000 as well as each type of the MEP-7000's cable jacks, please refer to "CONNECTIONS" in the operating instructions of your MEP-7000. 1 Connect the 5 V connector jack on the back of your MEP-7000's Control unit to the USB port on your computer with a USB auxiliary power cable. 2 Connect the PC connector on the back of your MEP-7000's control unit to a USB port on your computer with a USB cable. 3 Start up your computer. • It is also possible to start up your computer first and then make the connections to your MEP-7000. Warning! Manipulator Style For information on the Manipulator style, please refer to "USING DJ SOFTWARE" in your MEP7000's Operating Instructions. Updating your Version of DJS In order to use your MEP-7000 in conjunction with DJS, it is necessary to update DJS to version 1.600 or later. Please refer to the DJS User's Manual for directions on how to update your version of DJS. → 'Using the Support Site' Warning! Before Connecting to your Computer Disconnect the dedicated remote control cable that is connecting the MEP-7000 Control unit and the MEP-7000 Drive unit. Control Unit Power Supply The power for the control unit of the MEP-7000 is supplied from a USB port on your computer. Connect the USB cable and USB auxiliary power cable directly to your computer's USB ports. Do not connect them to a USB hub or any other kind of USB splitter. Starting up DJS Start up DJS after making the connections to the control unit of your MEP-7000. Also, take care to close DJS before disconnecting the control unit of your MEP-7000. DJS Ver. 1.600 7