Pioneer PRO-930HD Owner's Manual - Page 20
Cable connections for watching digital, and/or conventional TV channels
View all Pioneer PRO-930HD manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 20 highlights
05 Preparation Cable connections for watching digital and/or conventional TV channels This system is equipped with two terminals for inputting TV broadcasting signals: ANT/CABLE A IN and ANT B IN. The ANT/CABLE A IN terminal accepts both digital and conventional TV broadcasting signals while the ANT B IN terminal accepts only conventional TV broadcasting signals. When using cable TV to watch digital and/or conventional TV channels, connect to the ANT/CABLE A IN terminal as shown. In addition, you may connect an antenna to the ANT B IN terminal as shown; use an outdoor antenna to enjoy clearer pictures. If your outdoor antenna uses a 75-ohm coaxial cable with an F-type connector, plug it into the antenna terminal at the rear of the Media Receiver. Connecting a Cable box Use the INPUT 1 terminals to connect a Cable box. Media Receiver (rear) MONITOR OUT ANT/ CABLE A IN INPUT 2 G-LINK INPUT 3 I N OUT CONTROL ANT B IN SERVICE ONLY R-AUDIO-L VIDEO S-VIDEO INPUT 1 COM V Connecting VHF/UHF antennas and a Cable VHF antenna UHF antenna U/Vmixer AV cable (commercially available) Cable TV Coaxial ANT B IN ANT/ CABLE A IN Media Receiver (rear) Cable TV Coaxial Cable box NOTE • You can also connect to the INPUT 1 S-VIDEO terminal instead of the INPUT 1 VIDEO terminal; use a commercially available S-Video cable. • If using a Cable box that supports digital TV channels and has an RF output terminal, you can connect that terminal to the ANT/CABLE A IN terminal using a commercially available coaxial cable. • When connecting a Cable box to the INPUT 1 terminal, be careful not to loop the cable. NOTE • Be sure to connect coaxial cables as shown above. Signal reception may fail if not properly connected. • In order to watch cable TV channels, be sure to connect the cable to the ANT/CABLE A IN terminal. • The ANT/CABLE A IN and ANT B IN terminals must not receive the same signals. For example, do not connect a cable from a cable TV to both the ANT/CABLE A IN and ANT B IN terminals. Similarly, do not connect a cable from an antenna to both the ANT/CABLE A IN and ANT B IN terminals. 20 En