Poulan 358.351080 User Manual - Page 17

H, .=:i CUSTOMER RESPONSIBILITIES MAINTENANCE SCHEDULE ; ..... \ Fill in dates as you complete regularservice C"ecfkordamagoerdwornpa.s Check for loose fasteners and parts Check chain tension' Every Every Yearly BUefsoere t AUfsteer 5 Hrs. 25 Hrs. v" ! ,/ Service Dates Check chain sharpness €" Check guide bar'condition Check guide bar lube €" Clean unit & labels Clean air filter CleaWinspect spark arrestor screen & inspect muffler Replace spark plug R'ep'i'acfe,er 1....... ,,u v" GENERAL RECOMMENDATIONS The warranty on this unit does not cover items that have been subjected to operatorabuse or negligence.Toreceive full value from the warranty,the operatormustmaintain unit as instructedin this manual. Some adjustments will need to be made periodically to properly maintain your unit. All adjustments in the =Service and Adjustments"sectionof this manual should be checked at Ieast once each season, • Once a year, replacethe spark plug, replace air filter element and check guide bar and chain for wear. A new spark p{ug and a clean/new air filter element assures proper air-fuel mixture and helps your engine run better and last longer. • Follow the maintenance schedule in this manual. WARNING: DISCONNECT THE SPARK PLUG BEFORE PERFORMING MAINTENANCE EXCEPT FOR CARBURETOR ADJUSTMENTS. INSPECTTHE ENTIRE UNIT. REPLACE DAMAGED PARTS. CHECK FOR FUEL LEAKS AND MAKE SURE ALL FASTENERS ARE IN PLACE AND SECURELY FASTENED. BEFORE USE CHECK FOR DAMAGED OR WORN PARTS The followingdamaged/worn parts should be referred to your Sears Service Center. NOTE: It is normal for a small amount of oil to appear underthe saw after engine stops.Do not confuse this with a leakingoil tank. • On/Stop Switch ensure on/stop switch functionsprop- erly by moving the switch to the =Stop" position and assure that engine stops, then restart your engine and continue. o_Fuel Tank - discontinue use of chain saw ff fuel tank show signs of damage or leaks. • Oil Tank - discontinue use of chain saw if oil tank shows signs of damage or leaks. • Chain Catcher- replace chain catcher if bent, cut, or damaged in any way, CHECK FOR LOOSE • Bar Clamp Nut • Chain • Muffler ... . • Cylinder Shield • Air Filter ° Clutch Drum/Sprocket • Handle Screws • VibrationMounts ° Starter Housing • Handguard FASTENERS AND PARTS LUBRICATION CHART ®Bar @Bar Oil Sprocket Fill Cap Lube CHUAsIeNthTeEsNcSreIOwNddver(Feign.id o1f9th&e 2b0a)r tool to move chain aroundthe guide bar. • If chaindoes not rotate, it is too tight - slightty loosenpar clamp nuts and turn adjusting screw 1/4 turn counterclockwise.Retighten bar clamp nuts. • If chain is too loose, it will sag below the guide bar. Figure19. (D Craftsman chain saw bar oil ® Craftsman bar sprocket lube Sag -17- Figure 19