Poulan 532430614 User Manual - Page 2

8 Using a 7/16" socket, remove the nut and carriage bolt that hold the upper side bracket onto the bagger. 12. Using a 3/8" socket and Phillips head screw driver, reinstall the bagger cover and handles. 9 Lift up on the cross shaft and remove the upper side bracket from the bagger. 13. Route the jumper harness so that the eye loops and switch plug are in the battery hole and the actuator plug passes through the back plate along side of the bagger support bracket on the left side of the tractor. 10 Install the new upper bracket assembly from the kit by sliding it onto the cross shaft and then align the bolt holes. 14. Reinstall the battery. • Ensure the harness is routed over top of the battery from the rearward, right corner. 11 Using a 7/16" socket, reinstall the carriage bolt and nut to hold in the upper bracket assembly. • Connect the red wire to the positive terminal first, followed by the black wire to the negative terminal. Ensure the leads are flat against the battery before tightening down the hardware. 2