Poulan 532430614 User Manual - Page 4

25. Press the switch down to extend the actuator fully while supporting the actuator with your right hand. CAUTION: Do not allow the actuator to press into the back plate. 29. Reaching into the bagger, connect the actuator to the upper pivot bracket assembly using the 1-3/4" clevis pin. 30. Reach into the bag and use a clip provided in the kit to secure the 1-3/4" clevis pin. 31. Use the switch to raise the bagger and then reattach the bagger mesh to the side of the bagger frame. 32. Place the included warning label on the fender of the tractor. TO OPERATE ELECTRIC DUMP SYSTEM NOTE: For tractors that have the factory equipped electric dump system, the ignition switch must be in the "ON" position for the bagger to dump. Tractors retrofitted with the kit do not. WARNING: Keep fingers and objects clear of the bagger during operation. TO DUMP BAGGER Your tractor is equipped with a Dump Bag Alarm. To turn off the alarm disengage the attachment clutch control. CAUTION: Do NOT place objects on top of the bagger or lean on the bagger. • Position tractor in location you wish to dump bagger. • Ensure that the transaxle is in the neutral position. Set park- ing brake. • To dump clippings, activate the electric dump switch by turning the switch counterclockwise until bagger reaches its highest position. 26. With the actuator resting on the back plate, reinstall the bagger onto the back of the tractor. 27. Snap the hole cover from the kit into the hole in the bagger top where the dump handle was located. • To continue mowing, ensure that the area around the tractor is clear and carefully pull forward until the bagger has cleared the grass pile. Once the bagger is clear of the grass pile, stop the tractor, ensure the transaxle is in the neutral position, set the parking brake, and turn the dump switch clockwise until the bagger is completely down. 28. Unclip the mesh side from the bagger frame on the left side of the tractor to access the actuator assembly. NOTE: Extend or retract the actuator as needed to align the mounting hole with the upper bracket slot. IMPORTANT: The electric dump system may be equipped with an overload protection device. If the bagger system is overloaded, it will cut power to the system. The protection device will automatically reset after approximately 2 minutes. Once the system has reset, ensure that nothing is on top of or against the bagger that could overload the system. Open the bag slightly using the switch and then use a small rake or similar tool to scoop grass out of the bag. Once you have removed the excess load, attempt to dump the bagger using the electric dump system. 4