Poulan PPCRT17 Owner Manual - Page 10

OPERATION ADD GASOLINE • Fill fuel tank to bottom of filler neck. Do not overfill. Use fresh, clean, regular unleaded gasoline with a minimum of 87 octane. Do not mix oil with gasoline. Purchase fuel in quantities that can be used within 30 days to assure fuel freshness. CAUTION: Fill to within 1/2 inch of top of fuel tank to prevent spills and to allow for fuel expansion. If gasoline is accidentally spilled, move machine away from area of spill. Avoid creating any source of ignition until gasoline vapors have disappeared. Wipe off any spilled oil or fuel. Do not store, spill or use gasoline near an open flame. IMPORTANT: WHEN OPERATING IN TEMPERATURES BELOW32°F(0°C), USE FRESH, CLEAN WINTER GRADE GASOLINE TO HELP INSURE GOOD COLD WEATHER STARTING. CAUTION: Alcohol blended fuels (called gasohol or using ethanol or methanol) can attract moisture which leads to separation and formation of acids during storage. Acidic gas can damage the fuel system of an engine while in storage. To avoid engine problems, the fuel system should be emptied before storage of 30 days or longer. Drain the gas tank, start the engine and let it run until the fuel lines and carburetor are empty. Use fresh fuel next season. See Storage Instructions for additional information. Never use engine or carburetor cleaner products in the fuel tank or permanent damage may occur. TO START ENGINE (See Fig. 13) CAUTION: KEEP TINE CONTROL IN "OFF" POSITION WHEN STARTING ENGINE. When starting engine for the first time or if engine has run out of fuel, it will take extra pulls of the recoil starter to move fuel from the tank to the engine. 1. Make sure spark plug wire is properly connected. 2. Place the fuel valve to the "ON" position. 3. To start a cold engine, move the choke lever to the "ON" position. 4. Move the throttle lever away from the "SLOW" position, about 1/3 of the way toward the "FAST" position. 5. Turn the engine switch to the "ON" position. Pull rope out slowly until engine reaches start of compression cycle (rope will pull slightly harder at this point). 6. Pull recoil starter handle quickly. Do not let starter handle snap back against starter. Repeat if necessary. NOTE: If engine fires but does not start, move choke control to half choke position. Pull recoil starter handle until engine starts. 7. If the choke lever has been moved to the "ON" position to start the engine, gradually move it to the opposite position as the engine warms up. NOTE: A warm engine requires less choking to start. 8. Move throttle control to desired running position. 9. Allow engine to warm up for a few minutes before engaging tines. NOTE: If engine does not start, see trouble-shooting points. SPARK PLUG THROTTLE CONTROL FUEL ENGINE VALVE SWITCH CHOKE CONTROL RECOIL STARTER HANDLE Fig. 13 10