Poulan PR625Y22RHP Owner Manual - Page 9

ASSEMBLY TO PREPARE BATTERY (ELECTRIC START MODELS ONLY) NOTE: Your battery must be charged before you can start your lawn mower. • Open battery box (if equipped). • Disconnect engine connector (male) (if equipped) from battery connector (female). • Connect battery charger connector (male) to harness connector (female). • Plug battery charger into 110 volt A.C. outlet. • Leave battery charger connected for 24 hours before starting your engine for the first time. • Reconnect engine connector (male) (if equipped) to battery connector (female). • After charging, connect engine connector (male) (if equipped) to battery connector (female). Connect your battery charger to charge battery after each use. IMPORTANT: The engine will not recharge your battery. At the end of the mowing season the battery should be charged for 48 hours to protect the battery during winter storage. CAUTION: Always disconnect the engine connector from the battery con- nector to prevent accidental starting when transporting or storing your lawn mower after the season. HANDLE-MOUNTED KEY SWITCH Engine connector (male) Harness connector (female) Battery charger Charger connector (male) 22PLUS FRONT WHEEL DRIVE Engine battery connector (male) Battery charger Charger connector (male) Battery connector (female) DECK-MOUNTED BATTERY Battery charger Charger Harness connector connector (male) (female) Battery box 22PLUS REAR WHEEL DRIVE Battery charger Harness connector (female) Charger connector (male) Engine connector (male) Battery box 9