ProForm 1050t Treadmill English Manual - Page 12

12. Set the console assembly on the Left and Right Handrails (82, 83). Be careful not to pinch any wires. Insert the excess Upright Wire (87) into the Right Handrail. Attach the console assembly to the Crossbar (107) with six #8 x 3/4" Screws (1). Start all six Screws before tightening any of them. Attach the two Console Clamps (105) to the console assembly with four #8 x 1" Screws (53). 12 Console Assembly 87 105 53 107 83 1 1 82 1 13. Hold the Right Upright Cover (86) against the console assembly. Align the holes in the Right 13 Upright Cover with the holes in the Right Upright (85). Attach the Right Upright Cover with two #8 x 3/4" Screws (1). Attach the Left Upright Cover (80) to the Left 86 Upright (84) in the same way. See steps 4 and 6. Tighten the 3/8" x 4" Patch Bolts (7). 1 85 80 Console 1 Assembly 84 14. Raise the Frame (55) to the position shown. Have a second person hold the Frame until this step is completed. Orient the Storage Latch (51) so that the large barrel and the Latch Knob (52) are oriented as shown. Attach the upper end of the Storage Latch (51) to the bracket on the Frame (55) with a 3/8" x 2" Bolt (8) and a 3/8" Nut (10). Attach the lower end of the Storage Latch (51) to the Base (95) with a 3/8" x 1 3/4" Patch Bolt (6). Note: It may be necessary to move the Frame (55) back and forth to align the Storage Latch with the Base. Lower the Frame (55) (see HOW TO LOWER THE TREADMILL FOR USE on page 21). 14 10 55 8 51 52 Large Barrel 95 6 15. Make sure that all parts are properly tightened before you use the treadmill. If there are sheets of clear plastic on the treadmill decals, remove the plastic. To protect the floor or carpet, place a mat under the treadmill. Note: Extra hardware may be included. Keep the included hex keys in a secure place; one of the hex keys is used to adjust the walking belt (see pages 23 and 24). 12