ProForm 130 Elliptical English Manual - Page 7
Hub Screw across from the first Hub Screw. Then
View all ProForm 130 Elliptical manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 7 highlights
4. Hold a Hub Cover (75) and a Crank Arm (36) against 4 the left Crank Hub (38). Align the holes in the Hub 43 Cover and the Crank Arm with the unused holes in the left Crank Hub. Next, insert four Hub Screws (87) 98 36 into the Hub Cover and the Crank Arm, and finger 38 tighten the Hub Screws into the left Crank Hub. Tighten one of the Hub Screws, and then tighten the Hub Screw across from the first Hub Screw. Then, tighten the remaining two Hub Screws. 36 Repeat this step on the right side of the elliptical exer- 75 ciser; make sure that the Crank Arms (36) are ori- 87 ented so that the Crank Bushing Sleeves (43) are in the positions shown. Note: there are no Pulley Screws (98) on the right side. 87 43 5. While another person holds the Upright (3), connect 5 the Upper Wire Harness (48) to the Lower Wire Harness (49). Gently pull the upper end of the Upper Wire Harness to remove any slack, and insert the Upright into the Base (1). Attach the Upright with an M8 x 69mm Button Bolt (80), an M8 Split Washer (90), and an M8 Jamnut (79). Do not tighten the Button Bolt yet; make sure that the Jamnut is in the hexagonal hole in the Base. 80 90 Next, finger tighten two M8 x 23mm Button Screws (84) with M8 Split Washers (90) into the Base (1). Do not tighten the Button Screws yet. 90 Attach the Water Bottle Holder (22) to the Base (1) 84 with two M4 x 14mm Screws (104). 3 48 49 79 90 84 104 1 22 6. Orient one of the Upright Covers (17) as shown, and 6 hold it against the Upright (3). Attach the Upright Cover with two M4 x 16mm Round Head Screws (101). Attach the other Upright Cover in the same way. 17 101 3 101 17 7