ProForm 3.8 Treadmill Uk Manual - Page 11
Console Back. - mats
View all ProForm 3.8 Treadmill manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 11 highlights
13. Raise the Frame (56) to the position shown. Have a second person hold the Frame until 13 this step is completed. Orient the Storage Latch (53) so that the large barrel and the Latch Knob (54) are in the positions shown. Attach the lower end of the Storage Latch to the Latch Bracket (114) with a 3/8" x 2" Bolt (4) and a 3/8" Nut (8). Attach the upper end of the Storage Latch (53) to the bracket on the Frame (56) with a 3/8" x 2" Bolt (4) and a 3/8" Nut (8). Note: It may be necessary to move the Frame back and forth to align the Storage Latch with the bracket. Lower the Frame (56) (see HOW TO LOWER THE TREADMILL FOR USE on page 25). 56 8 4 53 54 Large Barrel 114 8 4 14. Make sure that all parts are properly tightened before you use the treadmill. If there are sheets of clear plastic on the treadmill decals, remove the plastic. To protect the floor or carpet, place a mat under the treadmill. Note: Extra hardware may be included. Keep the included hex keys in a secure place; the large hex key is used to adjust the walking belt (see pages 27 and 28). If you purchase the optional chest pulse sensor (see page 23), follow the steps below to install the receiver included with the chest pulse sensor. 1. Make sure that the power cord is unplugged. Remove the indicated 1/2" Screws (1) and the Access Door (87) from the Console Back (91). 2. Connect the wire on the receiver (A) to the indicated wire extending from the Console Back (91). Hold the receiver so the small cylinder is oriented as shown and is facing the Console Back. Attach the receiver to the plastic posts on the Access Door (87) with the two included small screws. 3. Make sure that no wires are pinched. Reattach the Access Door (87) with the 1/2" Screws (1). Discard the other wires included with the receiver. Small 91 Screws 87 A Wire Small 1 Cylinder 11