ProForm 3.8 Treadmill Uk Manual - Page 9
If The Connectors Are Not Con
View all ProForm 3.8 Treadmill manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 9 highlights
8. Attach the Latch Bracket (114) to the Base (83) with two 3/8" x 2" Bolts (4) and 3/8" Nuts (8). 8 With the help of a second person, tip the treadmill so that the Base (83) is flat on the floor. 83 8 114 4 9. Have a second person hold the Bridge (95) near the Right Upright (78). Remove the wire tie from 9 the Upright Wire (38). Connect the Upright Wire (38) to the Bridge Wire (52). See the inset drawing. The connectors should slide together easily and snap into place. If they do not, turn one connector and try again. IF THE CONNECTORS ARE NOT CONNECTED PROPERLY, THE CONSOLE MAY BE DAMAGED WHEN THE POWER IS TURNED ON. Wire Tie 95 52 38 78 52 38 10. Insert the indicated connectors into the Right Upright (78). Next, insert the fronts of the brackets on the Bridge (95) into the Uprights (74, 78), and then fully insert the brackets. Make sure that the plastic edges of the Bridge are inside the Uprights. Be careful not to pinch the wires. Attach the Bridge (95) with six 1/4" x 1/2" Bolts (7) and six 1/4" Star Washers (10); start the two indicated Bolts first before the other four Bolts and then tighten them. See steps 5 and 7. Tighten the four 3/8" x 4 1/2" Bolts (6). 10 10 7 Start First 74 9 95 Connectors 7 Front Edge 7 10 Start First 7 78