ProForm 300 Cr Bike English Manual - Page 18

MAINTENANCE AND TROUBLESHOOTING Inspect and tighten all parts of the exercise bike regularly. Replace any worn parts immediately. To clean the exercise bike, use a damp cloth and a small amount of mild soap. IMPORTANT: To avoid damage to the console, keep liquids away from the console and keep the console out of direct sunlight. HOW TO ADJUST THE REED SWITCH If the console does not display correct feedback, the reed switch should be adjusted. To adjust the reed switch, you must first remove the left pedal and the left front shield. Using an adjustable wrench, turn the left pedal clockwise and remove it. CONSOLE TROUBLESHOOTING If the console display becomes dim, or if the audio from the sound system stops intermittently, replace all the batteries at the same time; most console problems are the result of low batteries. See assembly step 5 on page 8 for replacement instructions. Note: If you use the sound system regularly, it is recommended that you purchase an optional manufacturer-supplied power adapter (see assembly step 5 on page 8). Next, remove all the screws from the left and right front shields; there are two sizes of screws in the front shields-note which size of screw you remove from each hole. Then, gently pull the left front shield away from the frame. Locate the Reed Switch (46). Turn the Pulley (29) until a Magnet (30) is aligned with the Reed Switch. Next, loosen, but do not remove, the indicated M4 x 16mm Screw (57). If the handgrip pulse sensor does not function properly, see step 5 on page 15. 29 30 46 57 Slide the Reed Switch (46) slightly closer to or away from the Magnet (30), and then retighten the M4 x 16mm Screw (57). Turn the Pulley (29) for a moment. Repeat these actions until the console displays correct feedback. When the reed switch is correctly adjusted, reattach the front shields and the left pedal. 18