ProForm 380 Razor Elliptical Uk Manual - Page 22
Maintenance And Troubleshooting
View all ProForm 380 Razor Elliptical manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 22 highlights
MAINTENANCE AND TROUBLESHOOTING Inspect and tighten all parts of the elliptical exerciser regularly. Replace any worn parts immediately. To clean the elliptical exerciser, use a damp cloth and a small amount of mild soap. IMPORTANT: To avoid damage to the console, keep liquids away from the console and keep the console out of direct sunlight. CONSOLE TROUBLESHOOTING If the console displays become dim, the batteries should be replaced; most console problems are the result of low batteries. See assembly step 5 on page 8 for replacement instructions. If the handgrip pulse sensor does not function properly, see step 5 on page 17. HOW TO ADJUST THE REED SWITCH If the console does not display correct feedback, the reed switch should be adjusted. First, remove all of the screws from both shields; there are three sizes of screws in the shields-note which size of screw you remove from each hole. Then, gently pry the shields away from the frame. HOW TO ADJUST THE BELT If you can feel the pedals slip while you are pedaling, even when the resistance of the pedals is at the highest setting, the Belt (46) may need to be adjusted. First, remove all the screws from both shields; there are three sizes of screws in the shields-note which size of screw you remove from each hole. Then, gently pry the shields away from the frame. Next, turn the Belt Adjustment Screw (72) until the Belt 46 (46) is tight. Then, reattach the shields. Note: If you have ques- tions as to which screw should be in which hole, see 72 EXPLODED DRAWING B on page 27 and the PART LIST on page 25. Next, locate the Reed Switch (58). Turn the Left Pedal Disc (26) 58 41 26 until a Magnet 84 (41) is aligned with the Reed Switch. Loosen, but do not remove, the indi- cated M4 x 16mm Round Head Screw (84). Slide the Reed Switch slightly closer to or away from the Magnet, and then retighten the Screw. Rock the Left Pedal Disc forward and backward just enough that the Magnet passes the Reed Switch repeatedly. Repeat until the console displays correct feedback. When the Reed Switch is correctly adjusted, reattach the shields. Note: If you have questions as to which screw should be in which hole, see EXPLODED DRAWING B on page 27 and the PART LIST on page 25. 22