ProForm 400 X Treadmill English Manual - Page 8
Damaged When The Power Is Turned On.
View all ProForm 400 X Treadmill manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 8 highlights
5. Loosen the two Crossbar Screws (98) (only one is shown) 5 several turns. Place the Console Base (87) on the Right Handrail (16) and the Left Handrail (not shown). Make sure that the Wire Harness (53) is not pinched by the Right Handrail. Attach the Console Base with four 3/4" Screws (5) (only two Screws are shown). Start all four Screws before tightening any of them. 87 53 10 Insert the Wire Harness (53) through the two indicated plastic ties on the Console Base (87). Next, insert the Wire Harness up through the opening beside the Wire Cover (10). Make sure that the Wire Cover is securely attached to the Console Base. See the inset drawing. Look at the top of the Console Base (87). Insert the Wire Harness (53) through the plastic tie on top of the Console Base. Ties 5 98 16 53 Tie 87 6. Hold the Console (10) near the Console Base (87). Touch the Right Handrail (16) to discharge any static. See the inset drawing. Find the 2-wire connector on the end of the Wire Harness (53). Insert the connector into the red socket beneath the Console. The connector should slide in easily and snap into place. If it does not, turn the connector and then insert it. Insert the 6wire connector into the other socket beneath the Console the same way. Insert the excess Wire Harness (53) down through the opening in the Console Base (87) (see the inset drawing in step 5). Securely tighten the plastic tie on top of the Console Base to prevent the Wire Harness from slipping. Then, cut off the end of the plastic tie. Make sure that the connectors and wires appear as shown at the right. IF THE CONNECTORS ARE NOT INSERTED PROPERLY, THE CONSOLE MAY BE DAMAGED WHEN THE POWER IS TURNED ON. See drawing 6a. Press the Bookrack (85) onto the Console Base (87) in the location shown. Set the Console (10) on the Console Base (87). Insert the excess Wire Harness (53) into the large hole in the side of the Right Handrail (16). Securely tighten the plastic ties on the bottom of the Console Base to prevent the Wire Harness from slipping. Then, cut off the ends of the plastic ties. Attach the Console (10) to the Console Base (87) with two 3/4" Screws (5) and four 1/2" Screws (97). Start all six Screws before tightening any of them; do not overtighten the Screws. 6 53 10 Ties 87 97 98 5 5 97 16 97 53 6-wire 2-wire 6a 85 87 8