ProForm 465 S Uk Manual - Page 10
How The Pacer Programs Operate
View all ProForm 465 S manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 10 highlights
HOW THE PACER PROGRAMS OPERATE The console offers three motivational Actual pacer programs. Each program lasts for twenty minutes. When you use a pacer program, two Target columns of bars will appear in the display. The left column represents a target pace, and the right column shows your actual pedaling pace. The target pace will change periodically during the program; as the target pace changes, simply change your pedaling pace to keep both columns at the same height. Important: The target pace is a goal pace. Your actual pace may be slower than the target pace, especially during the first few months of your exercise program. Be sure to exercise at a pace that is comfortable for you. STEP-BY-STEP CONSOLE OPERATION Before the console can be operated, two 1,5V batteries must be installed. (See step 9 on page 8.) 1 Turn on the power. To turn on the power, press the on/reset button or simply begin pedaling. The entire display will appear for two seconds; the console will then be ready for use. Note: If batteries were just installed, the power will already be on. 2 Select one of the three pacer programs or the manual mode. To select one of the pacer Program Indicator programs, repeatedly press the pro- gram button. The program indicator will show which program you have select- ed. To select the manual mode, press the program button until the program indicator disappears. The programs will be select- ed in the following order: program 1, program 2, program 3, manual mode. 3 Begin your workout. If you selected the manual Actual mode, go to step 4. If you selected one of the pacer programs, two columns of Target bars will appear in the display. The left column will show one bar, indicating a relatively slow pace. The right column will show your actual pedaling pace. Change your pace until only one bar appears in the right column. Each time the target pace changes during the program, change your pedal- ing pace to keep both columns at the same height. 4 Follow your progress with the monitor modes. The scan mode- Repeatedly press the display button Mode Arrows until an arrow appears under the word "scan." When the scan mode is selected, the console will display the speed, time, distance, fat calories, and calo- ries modes, for five seconds each, in a repeating cycle. The speed, time, distance, fat calories, or calories mode-To select one of these modes for continuous display, repeatedly press the display button until an arrow appears below or above the desired mode. Make sure that there is not an arrow under the word "scan." To reset the display, press the on/reset button. 5 Turn off the power. To turn off the power, simply wait for about six minutes. If the pedals are not moved and the console buttons are not pressed for six minutes, the power will turn off automatically. 10