ProForm 465 S Uk Manual - Page 5
Assembly
View all ProForm 465 S manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 5 highlights
ASSEMBLY Assembly requires two people. Place all parts of the elliptical trainer in a cleared area and remove the packing materials. Do not dispose of the packing materials until assembly is completed. In addition to the included allen wrench, assembly requires a phillips screwdriver spanners , a rubber mallet , and a pair of pliers , two adjustable . Use the chart below to identify the small parts used in assembly. The number in parenthesis below each part refers to the key number of the part, from the PART LIST on page 14. The number after the dash indicates the quantity needed for assembly. Note: Some parts may have been pre-attached for shipping. If a part is not in the parts bag, check to see if it has been pre-attached. M8 Nylon Locknut (38)-6 M10 Nylon Locknut (33)-6 M10 Split Washer (59)-2 M8.5 Washer (35)-2 M10.5 Washer (55)-2 M4 x 12mm Screw (42)-4 M4 x 19mm Flange Screw (36)-6 M8 x 25mm Button Screw (56)-2 M8 x 45mm Bolt (50)-4 M10 x 74mm Button Bolt (67)-2 M10 x 75mm Carriage Bolt (34)-4 Pedal Arm Bolt Set (40)-2 1. Identify the Front Stabiliser (10). Whilst another person lifts the front of the Frame (1), attach the Front Stabiliser to the Frame with two M10 x 75mm Carriage Bolts (34) and two M10 Nylon Locknuts (33). Make sure that the Front Stabiliser is turned so the Wheels (22) are not touching the floor. 1 22 22 10 1 33 34 5