ProForm 510 Ex Elliptical English Manual - Page 10
Attach the Rear Upright Cover 24 to the Upright
View all ProForm 510 Ex Elliptical manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 10 highlights
9. Attach the Rear Upright Cover (24) to the Upright (5) with four M4 x 16mm Screws (93). 9 93 5 24 10. Attach the Front Upright Cover (25) around the Upright (5) by pressing the tabs on the Front 10 Upright Cover into the Rear Upright Cover (24). 25 5 24 11. Identify the Short Pedal Arm Axles (115) and the Long Pedal Axles (not shown). Apply a small amount of grease to a Short Pedal Arm Axle (115) and to an M8 x 23mm x 1.5mm Washer (126). Next, tighten an M8 x 16mm Screw (102) and an M8 x 23mm x 1.5mm Washer (126) a few turns into one end of the Short Pedal Arm Axle (115). Orient a Pedal Arm (12) as shown. While a second person holds the front end of the Right Pivot Arm (51) inside the bracket on the Pedal Arm, insert the Short Pedal Arm Axle (115) through both parts. Tighten another M8 x 16mm Screw (102) and an M8 x 23mm x 1.5mm Washer (126) a few turns into the Short Pedal Arm Axle (115). Then, tighten both Screws at the same time. Repeat this step on the other side of the elliptical. 11 102 126 Grease 115 12 51 126 102 10