ProForm 510 Ex Elliptical English Manual - Page 25
Next, remove the M4 x 16mm Round Head Screws
View all ProForm 510 Ex Elliptical manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 25 highlights
HOW TO ADJUST THE DRIVE BELT If you can feel the pedals slip while you are pedaling, even when the resistance is adjusted to the highest level, the drive belt may need to be adjusted. Next, remove the M4 x 16mm Round Head Screws (127) and the M4 x 42mm Screws (124) from the Right and Left Shields (18, 19). Make sure to note which size of Screw you remove from each hole. Then, gently remove the Left Shield. To adjust the drive belt, you must remove the top shield Loosen the Pivot Screw (97). Then, tighten the Belt and the left shield (see the instructions below). Adjustment Screw (85) until the Drive Belt (38) is tight. Using a flat screwdriver, release the tabs on the front and rear of the Top Shield (20), and then remove the Top Shield. 38 20 127 97 18 124 127 85 19 127 124 124 When the Drive Belt (38) is tight, tighten the Pivot Screw (97). Then, reattach the left shield and the top shield. 25