ProForm 530i Treadmill User Manual - Page 6

ASSEMBLY Assembly requires two persons. Set the treadmill in a cleared area and remove all packing materials. Do not dispose of the packing materials until assembly is completed. Note: The underside of the treadmill walking belt is coated with high-performance lubricant. During shipping, a small amount of lubricant may be transferred to the top of the walking belt or the shipping carton. This is a normal condition and does not affect treadmill performance. If there is lubricant on top of the walking belt, simply wipe off the lubricant with a soft cloth and a mild, non-abrasive cleaner. Assembly requires the included allen wrenches and your own phillips screwdriver , wire cutters , rubber mallet , and adjustable wrench . For help identifying assembly hardware, refer to the drawings below. Note: The assembly hardware and other small parts are packaged in separate part bags. Do not open the part bags until instructed to do so. If a part is not found in the part bags, check to see if the part has been preattached. Pulse Bar Screw (68)-4 3/4" Screw (6)-10 3/4" Tek Screw (47)-6 Wheel Bolt (107)-2 1/2" Ground Screw (114)-1 1/4" Star Washer (92)-4 5/16" x 3 1/2" Bolt (93)-4 1" Bolt (71)-4 3/8" x 3 1/2" Bolt (81)-2 Wheel Nut (21)-2 5/16" Star Washer (104)-4 1. With the help of another person, carefully tip the tread- 1 mill onto its left side. Identify the Right Upright (82); the 83 indicated bracket on the Right Upright overhangs on the left side as shown. Make sure that there are two U-Nuts (105) in the lower end of the Right Upright (see the inset drawing). Feed the Wire Harness (83) into the lower end 82 of the Right Upright, and pull the Wire Harness out of the hole in the upper end of the Right Upright. Note: There may be a tie on the Wire Harness to help you pull it out Bracket of the hole. Notch Open part bag A. Attach the Right Upright (82) to the right side of the Base (109) with two 5/16" x 3 1/2" Bolts (93) and two 5/16" Star Washers (104). Do not tighten 99 the Bolts yet. Be careful not to damage the Wire Harness (83). Attach the Left Upright (not shown) to the 82 left side of the Base in the same way. Note: There is not a wire harness on the left side. Press the two Base Endcaps (99) into the Base (109) (only one is shown). Make sure that the notch in each Base Endcap is at the top as shown. Note: The Base 105 Endcaps may be preassembled. 6 109 104 93