ProForm 530i Treadmill User Manual - Page 7

2. Attach the six Base Pads (100) (three are shown) to the bottom of the Base (109) with six 3/4" Tek Screws (47). 2 Note: The 3/4" Tek Screws are found in part bag C. 100 47 100 47 109 100 47 3. With the help of another person, raise the Right Upright (82) and the Left Upright (not shown) to the vertical position. Hold the Crossbar (90) between the Uprights, and align the notches in the Crossbar with the indicated welds on the Uprights. Attach each end of the Crossbar with a 3/8" x 3 1/2" Bolt (81) and a Crossbar Endcap (84) (only the right side is shown). Make sure that the Crossbar Endcaps are turned so the notches are aligned with the welds on the Uprights. Do not tighten the Bolts yet. 3 90 Notch Welds 82 84 81 Notch 4. Turn the Console Base (85) upside-down; be careful not to scratch the Console Base. Remove the bands and the 4 Console Back (not shown) from the Console Base. Hold the ends of the Pulse Bar (110) against the Console Base as shown. Connect the Pulse Wire (118) in the Console Base to the pulse wire in the Pulse Bar (see the inset drawing). The connectors should slide together easily and snap into place. If the connectors do not slide together easily and snap into place, turn one con- nector and try to connect them again. Open part bag B. Have another person hold the Pulse Bar (110) firmly against the underside of the Console Frame (7). Attach the Pulse Bar with four Pulse Bar Screws (68) (only two are shown). Note: The Pulse Bar Screws may be preattached and may need to be removed. Firmly tighten the Screws. Be careful not to damage the wires. Attach the round ring on the ground wire to the Console Frame (7) with a 1/2" Ground Screw (114). Note: There are no wires on the other side of the Pulse Bar (110). 110 68 85 114 7 118 Ground Wire 118 7