ProForm 600 Zlt Treadmill Uk Manual - Page 11
M8 x 25mm Patch Bolts 5, two M8 Star
View all ProForm 600 Zlt Treadmill manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 11 highlights
9. Set the console assembly face down on a soft surface to avoid scratching the console. 9 Loosen the four #8 x 1" Screws (107). Carefully pivot the Console Frame (111) to the position shown. Do not pivot the Console Frame too far or you will break the ground wire. 104 Identify the Left and Right Accessory Trays (104, 106). Attach the Accessory Trays to the console assembly with eight M4 x 13mm Screws (116). Carefully pivot the Console Frame (111) back down to the console assembly. 116 116 106 107 111 Console Assembly 10. Identify the Right Handrail (101) which is marked with a "Right" sticker. Remove the tie 10 from the Right Handrail. If necessary, press the M8 Cage Nut (34) back into place. Hold the Right Handrail (101) near the console assembly. Route the console wire around the side of the Right Handrail as shown, and through the slot in the Right Handrail. Console Wire 108 73 34 Tie If necessary, adjust the Console Frame (111) to align the holes in the Right Handrail (101) with the holes in the Console Frame. Attach the Right Handrail (101) to the Console Frame (111) and the console assembly with two M8 x 25mm Patch Bolts (5), two M8 Star Washers (10), an M5 x 16mm Bolt (108), and a 1/4" Star Washer (73). Make sure the console wire is not pinched. Start all three Bolts, and then tighten all of them. Slot Console Assembly Attach the Left Handrail (not shown) as de- scribed above. Note: There is not a wire on the left side. 107 Tighten the #8 x 1" Screws (107). Be carful not to overtighten the Screws. 5 10 101 111 11