ProForm 600 Zlt Treadmill Uk Manual - Page 14

If you purchase the optional chest pulse sensor (see page 23), follow the steps below to install the receiver included with the chest pulse sensor. 1. Make sure that the power cord is unplugged. Remove the five M4 x 19mm Screws (35) and 1 the two M4 x 45mm Screws (2) from the back of the console assembly. Console Assembly 35 2 2 35 35 2. Carefully lift the console assembly off of the Console Base (103). Locate the Pulse Wire (A) on the console assembly. 2 103 35 Console Assembly A 3. Connect the wire on the Receiver (B) to the 3 Pulse Wire (A). Peel the paper backing off the pad on the bottom of the Receiver (B) and off the console pad. Next, hold the Receiver so that the antenna is oriented as shown. Press the Receiver onto the console pad. Remove the Wire Holder (C). Place the wire on the Receiver (B) between the two plastic pins and press the Wire Holder back on. 4. See step 1. Reattach the console assembly. Make sure that no wires are pinched. Discard the other wires included with the receiver. 14 Antenna Pad B Wire A Console Assembly Console Pad C