ProForm 640 English Manual - Page 10
Note: The above steps may have been pre-assem, bled by the factory.
View all ProForm 640 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 10 highlights
12. Press a 2" Square Inner Cap (17) into each end of the Leg lever (18). Press a 48mm Round Inner Cap (12) into the end of the weight tube (G). Note: The above steps may have been pre-assembled by the factory. 12 17 17 18 12 G 13. Lubricate the M10 x 72mm Bolt (59). Attach the Leg Lever (18) to the bracket (H) on the Front Leg (19) with the M10 x 72mm Bolt (59) and an M10 Nylon Locknut (1). 13 H 19 1 18 17 59 Lubricate 14. Press a 3/4" Round Inner Cap (54) into each end of 14 the three Pad Tubes (46 and 48). 10 19 Insert a Short Pad Tube (48) through the upper hole in the Leg Lever (18). Slide two Foam Pads (10) onto the Pad Tube. Insert the Long Pad Tube (46) through the lower hole in the Leg Lever (18). Slide two Foam Pads (10) onto the Pad Tube. 54 18 10 48 H 48 54 Insert a Short Pad Tube (48) through one set of holes in the bracket (H) on the Front Leg (19). Slide two Foam Pads (10) onto the Pad Tube. 10 46 54 15. Attach the Cable (45) to the Weight Carriage (37) 15 with the M10 x 19mm Bolt (8) and an M10 Nylon Locknut (1). 45 8 1 37 10