ProForm 7.5 Distance Trainer Treadmill English Manual - Page 11
Console Base.
View all ProForm 7.5 Distance Trainer Treadmill manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 11 highlights
13. Press the Left Accessory Tray (99) and the 13 Right Accessory Tray (106) into the Console Base (91). 91 99 106 14. Make sure that all parts are properly tightened before you use the treadmill. If there are sheets of clear plastic on the treadmill decals, remove the plastic. To protect the floor or carpet, place a mat under the treadmill. Note: Extra hardware may be included. Keep the included hex keys in a secure place; the large hex key is used to adjust the walking belt (see pages 27 and 28). If you purchase the optional chest pulse sensor (see page 24), follow the steps below to install the receiver included with the chest pulse sensor. 1. Make sure that the power cord is unplugged. Remove the indicated #8 x 3/4" Screw (1) and the Access Door (87) from the Console Base (91). 2. Connect the wire on the receiver (A) to the indicated wire extending from the Console Base (91). Hold the receiver so the small cylinder is oriented as shown and is facing the Console Base. Attach the receiver to the plastic posts on the Access Door (87) with the two included small screws. 3. Make sure that no wires are pinched. Reattach the Access Door (87) with the #8 x 3/4" Screws (1). Discard the other wires included with the receiver. Wire Small 91 Screws 87 A 1 Small Cylinder 11