ProForm 7.5 Distance Trainer Treadmill English Manual - Page 9

7. Set the console assembly face down on a soft 7 surface to avoid scratching the console assem- bly. Hold the Right Handrail (95) near the con- sole assembly. Next, insert the console wire into the large hole in the bottom of the Right Handrail and out of the top as shown. If necessary, use needlenose pliers to help pull the con- Console Wire sole wire out. 95 1 Attach the Right Handrail (95) and the Left 1 Handrail (not shown) with four #8 x 3/4" Screws (1) (only one side is shown). Make sure that no wires are pinched. Start all four Screws be- fore tightening any of them; do not over- Console tighten the Screws. Assembly 8. Tighten a 1/4" x 1 1/4" Bolt (5) with a 1/4" Star 8 Washer (33) into the bracket and Handrail Crossbar (94) on each side of the console as- sembly (only one side is shown). Remove the wire tie from the console wire. Console Wire Wire Tie 5 33 Bracket Console Assembly 9. Remove the long tie from the Upright Wire (38). Have a second person hold the console assembly near the Right Upright (78) and Left Upright (not shown). Connect the Upright Wire (38) to the console wire. See the inset drawing. The connectors should slide together easily and snap into place. If they do not, turn one connector and try again. IF THE CONNECTORS ARE NOT CONNECTED PROPERLY, THE CONSOLE MAY BE DAMAGED WHEN THE POWER IS TURNED ON. Set the console assembly on the Right Upright (78) and Left Upright (not shown). Be careful not to pinch the wires. 9 Console Assembly Console Wire 78 94 38 Long Tie Console Wire 38 9